| Форумы
ЧАТ |
Орешник |
|
| Форумы -» | Основная («Начинающим»)/ Базы / WinAPI / Компоненты / Сети / Media / Игры / Corba и COM / KOL / FreePascal / .Net / Прочее / RSDN.ORG |
|
| ||
|
|
Новости |
Поиск |
FAQ |
Статьи |
Книги |
Новости VCL
| | Форумы ЧАТ |
Орешник |
|
| |||
| |||
| |||
« предыдущая ветвь | форум | следующая ветвь »
Out of synchronization in MCK
Boguslaw © (2003-12-27 12:57:00)Hello,
I have strange problem with on of my programs (rather large) in KOL. I discovered that project is out of synchronization between VCL and MCK - so any of UnitX_X.inc is not updated anymore ! Could You give me a solution ? I checked and Locked property is set to false.I would add some controls to my KOL forms but by hand is impossible becouse from time to time UnitX_X.inc files are reconstructed (but not all the time) I'm using Delphi 5 Std with KOL 1.89.
Best Regards
Boguslaw
Gandalf (2003-12-28 13:27:00) [1]Скорее это повод еще раз всем свой MCK код проверить, хотя порой там твориться что-то странное, я векоторых проектах - обложив их всех try finally (MCK код контрлов) - так и не смог найти причину блокировки.
Boguslaw (2003-12-27 15:12:00) [2]Thank You. I figure it. I just create console mode application and paste all lines from my old dpr and include files into it (this way I create a fresh dpr file without reincluding forms) After opening of project all UnitX-X.inc were recreated and I must only set search paths and some other project options.
This MCK bug is probably another reason to incorporate all MCK code into some IDE with form designer. I know that BloodShed software are planning to support designers in they DeVC++, but DEvPas is abandoned anyway (maybe Licence issue ? - could someone create GPL-ed IDE for Pascal using Delphi?).
Best Regards
Boguslaw Brandys
Gandalf (2003-12-27 13:15:00) [3]Иногда такое бывает, говорят дело в кривых MCK контролах, лечилось удаление контров до тех пор пока не станет внось генериться код и установкой их по новой...
| |
